Level 1    , 'j'

  Quick Help:
     Display Hardware Jumper Setting, j[HardwareJumperSelect]

    This diagnostic command display hardware jumper settings.

  Input Parameters:

    0 - Hardware Jumper Select.
        This input parameter selects which hardware jumper will be checked and its setting
        will be displayed.
        Please refer to the following list of values to select the hardware jumper.

        0x00: SATA Configuration Hardware Jumper
          Type:    Unsigned 32-bit value
          Range:   0 to 0xFFFFFFFF
          Default: 0 (SATA Jumper)
  Output Data:

    If an error occurred, the following information will be displayed.
          "DiagError aaaaaaaa"
          aaaaaaaa is the Diagnostic Error Code
    If no error occurred, the setting of the requested hardware jumper will be displayed as follows.
          "Jumper is ss..ss"
          ss..ss is either "installed" or "not installed"

    Example #1:
    Display SATA configuration hardware jumper setting

       F3 1>j0

  Revision History:

    0001.0000   Initial revision.