Availability:
     Level F    , 'b'
     Level T    , 'B'

  Quick Help:
     Set Baud Rate, b[BaudRate],[MsecDelay]

  Description:
    The Set Baud Rate command sets the serial port baud rate to the specified value.

  Input Parameters:

    0 - Desired Baud Rate.
    
        This parameter specifies the desired serial port baud rate.  If this parameter
        is not entered or a value of 0 is entered, the baud rate will be set to the
        default value.  If an unsupported baud rate value is entered, a list of the
        valid baud rates will be displayed.
    
          Type:    Decimal value
    
          Range:   0 to 9999999
    
          Default: 38400
    
    1 - Delay Time in Milliseconds.
    
        This parameter specifies the number of milliseconds that the drive will wait for
        the host to send a carriage return at the new baud rate.  If a carriage return
        is not received within the specified amount of time, the baud rate will be set
        back to its value before the command was received.  If this parameter is not
        entered or a value of 0 is entered, the drive will not wait for a carriage return
        after selecting the specified baud rate.
    
          Type:    Unsigned 16-bit value
    
          Range:   0 to 0xffff
    
          Default: 0
    
  Output Data:
    If an unsupported baud rate value is entered, this command will display a list
    of the supported baud rates.

  Revision History:

    0001.0000   Initial revision.
    0011.0000   Combined the PSG Diagnostic Error Codes (PSGDEC) and the Diagnostic External
                Test Service Error Codes (DETSEC) into a single set of Diagnostic Error Codes
                (DiagError).