Availability:
     Online     , CTRL-P

  Quick Help:
     Toggle Diag Idle Mode

  Description:
    This command toggles the selected idle mode features.  If the selected features are
    enabled, this command will disable them.  If the selected features are disabled, this
    command will enable them.

    Features are selected [ and enabled ] by being enabled with the level 2 M command.

  Input Parameters:
    None

  Output Data:


     If an error occurred, the following information will be displayed.
     
           "DiagError aaaaaaaa"
     
        where
     
           aaaaaaaa is the Diagnostic Error Code
     
     If no error occurred, then the following will be displayed:
    
           "                Dithering xxx  ctl-P yyyyyyyyyyy"
           "                      TCC xxx  ctl-P yyyyyyyyyyy"
           "Continuous heat to writer xxx  ctl-P yyyyyyyyyyy"
           "MR chop / cnt. preamp pwr xxx  ctl-P yyyyyyyyyyy"
           "                    PFast xxx  ctl-P yyyyyyyyyyy"
           " Continuous channel power xxx  ctl-P yyyyyyyyyyy"
    
        where
    
           xxx      is either "On" or "Off"
    
           yy..yy   is either "toggles" or "won't toggle"
    
  Revision History:

    0001.0000   Initial revision.
    0011.0000   Combined the PSG Diagnostic Error Codes (PSGDEC) and the Diagnostic External
                Test Service Error Codes (DETSEC) into a single set of Diagnostic Error Codes
                (DiagError).