Availability:
     Online     , CTRL-E

  Quick Help:
     Display Native Interface Configuration

  Description:
    This command displays the Native Interface configuration information.

  Input Parameters:
    None

  Output Data:


    If an error occurred, the following information will be displayed.
    
          "DiagError aaaaaaaa"
    
       where
    
          aaaaaaaa is the Diagnostic Error Code
    

    If no error occurred and the native interface is AT or SATA, the following information
    will be displayed.
    
          "CurrentCHS=cccc/dd/ee  MltSiz=fgg  DMAMod=hi"
    
       where
    
          cccc  is the number of Current Logical Cylinders
    
          dd    is the number of Current Logical Heads
    
          ee    is the number of Current Logical Sectors
    
          f     is the AT Interface Multiple Block validity, 0 = Disabled 1 = Enabled
    
          gg    is the AT Interface Multiple Block Size
                This is valid only if AT Interface Multiple Block validity, f above, is 1
    
          h     is the current AT Interface DMA Mode. 2 = Multiword DMA 4 = Ultra DMA
    
          i     is the current AT Interface DMA Mode Level
                This is valid only if current AT Interface DMA Mode, h above, is valid
    
    If the Native Interface type is unsupported, the following message will be displayed.
    
          "Unsupported Native Interface Type"
    
  Revision History:

    0001.0000   Initial revision.
    0011.0000   Combined the PSG Diagnostic Error Codes (PSGDEC) and the Diagnostic External
                Test Service Error Codes (DETSEC) into a single set of Diagnostic Error Codes
                (DiagError).