Availability:
     Level G    , 'F'

  Quick Help:
     Fill Super Parity RAM, F[StartAddr],[EndAddr],[Pattern]

  Description:
    This command fills the specified segment of the Super Parity RAM with the specified
    data pattern.

  Input Parameters:

    0 - Start Address Offset of Super Parity RAM.
    
        This parameter specifies the start address offset of the super parity RAM.
    
          Type:    Unsigned 16-bit value
    
          Range:   0 to 0xffff,
    
          Default: 0
    
    1 - End Address Offset of Super Parity RAM.
    
        This parameter specifies the end address offset of the super parity RAM.
    
          Type:    Unsigned 16-bit value
    
          Range:   0 to 0xffff
    
          Default: 0
    
    2 - Data Pattern.
    
        This parameter specifies the fill pattern. The specified pattern is assumed
        to be right justified. If the value of the input pattern is 0x0FFF, the Write
        Super Parity RAM diagnostics will set the pattern to 0 to start the write.
        After each writing to the even address location, the value of the pattern
        will be incremented for the next even address location. If the pattern
        reaches the value of 0x0FFF, the pattern will be wrapped back to 0 for the
        next write.
    
          Type:    Unsigned 16-bit value
    
          Range:   0 to 0x0fff
    
          Default: 0
    
  Output Data:

    If an error occurred, the following information will be displayed.
    
          "DiagError aaaaaaaa"
    
       where
    
          aaaaaaaa is the Diagnostic Error Code
    
  Revision History:

    0001.0000   Initial revision.
    0011.0000   Combined the PSG Diagnostic Error Codes (PSGDEC) and the Diagnostic External
                Test Service Error Codes (DETSEC) into a single set of Diagnostic Error Codes
                (DiagError).