Availability:
     Level G    , 'D'

  Quick Help:
     Display Correction Buffer, D[StartAddr],[EndAddr],[CompareData]

  Description:
    This command displays the specified segment of Correction Buffer with the expected
    data pattern.

  Input Parameters:

    0 - Start Address Offset of Correction Buffer.
    
        This parameter specifies the start address offset of the correction buffer.
    
          Type:    Unsigned 16-bit value
    
          Range:   0 to 0xffff,
    
          Default: 0
    
    1 - End Address Offset of Correction Buffer.
    
        This parameter specifies the end address offset of the correction buffer.
    
          Type:    Unsigned 16-bit value
    
          Range:   0 to 0xffff
    
          Default: 0
    
    2 - Expected Data Pattern.
    
        This parameter specifies the expected pattern. The specified pattern is
        assumed to be right justified. If the value of the patten is greater than
        0x03FF, the command will take the lower 10 bits of the address as its
        pattern to compare with the data read from the Correction Buffer.
    
          Type:    Unsigned 16-bit value
    
          Range:   0 to 0x03ff
    
          Default: 0
    
  Output Data:

    If an error occurred, the following information will be displayed.
    
          "DiagError aaaaaaaa"
    
       where
    
          aaaaaaaa is the Diagnostic Error Code
    
  Revision History:

    0001.0000   Initial revision.
    0011.0000   Combined the PSG Diagnostic Error Codes (PSGDEC) and the Diagnostic External
                Test Service Error Codes (DETSEC) into a single set of Diagnostic Error Codes
                (DiagError).