Availability:
     Level G    , 'B'

  Quick Help:
     Fill Correction Buffer, B[StartAddr],[EndAddr],[Pattern],[Opts]

  Description:
    This command fills the specified segment of Correction Buffer with the specified data
    pattern. If the verification of fill is enabled, the command reads the data back and
    compares with the patten it writes.

  Input Parameters:

    0 - Start Address Offset of Correction Buffer.
    
        This parameter specifies the start address offset of the correction buffer.
    
          Type:    Unsigned 16-bit value
    
          Range:   0 to 0xffff,
    
          Default: 0
    
    1 - End Address Offset of Correction Buffer.
    
        This parameter specifies the end address offset of the correction buffer.
    
          Type:    Unsigned 16-bit value
    
          Range:   0 to 0xffff
    
          Default: 0
    
    2 - Data Pattern.
    
        This parameter specifies the fill pattern specified. The specified pattern
        is assumed to be right justified. If the value of the patten is greater
        than 0x03FF, the command will take the lower 10 bits of the address as its
        pattern to write in the Correction Buffer instead of the input pattern.
    
          Type:    Unsigned 16-bit value
    
          Range:   0 to 0x03ff
    
          Default: 0
    
    3 - Options.
    
        This parameter is a bit-significant value that selects the following options.
    
          Bits 15-1:  not used
    
          Bit 0:      Verify the patten written to the correction buffer.
    
                      If this bit is cleared, the patten is written into the correction
                      buffer without the verification of reading back and comparing
                      with the written patten.
    
                      If this bit is set, the patten is written into the correction
                      buffer followed by the verification of reading back and comparing
                      with the written patten.
    
          Type:    Unsigned 8-bit value
    
          Range:   0 to 0xff
    
          Default: 0
    
  Output Data:

    If an error occurred, the following information will be displayed.
    
          "DiagError aaaaaaaa"
    
       where
    
          aaaaaaaa is the Diagnostic Error Code
    
  Revision History:

    0001.0000   Initial revision.
    0011.0000   Combined the PSG Diagnostic Error Codes (PSGDEC) and the Diagnostic External
                Test Service Error Codes (DETSEC) into a single set of Diagnostic Error Codes
                (DiagError).