Availability:
     Level C    , 'Q'

  Quick Help:
     Display ASCII Command Information, Q[CmdLevel],[Cmd]

  Description:
    This command displays the revision of the specified ASCII serial port diagnostic
    command.

  Input Parameters:

    0 - Diagnostic Command Level.

        This parameter specifies the Diagnostic Command Level of the ASCII Serial Port
        Diagnostic Command for which the revision is to be displayed.  Entering a value
        of '0' selects the All Level commands.  Entering a value of '^' selects the
        Online commands.
     
          Type:    ASCII character

          Range:   Any printable ASCII character

          Default: None.  If this parameter is not entered, the revision of all supported
                   ASCII commands in all supported command levels will be displayed.

    1 - Diagnostic Command.

        This parameter specifies the ASCII Diagnostic Command for which the revision
        is to be displayed.

        If the Online commands are selected by entering a '^' for Parameter 0 and an
        upper or lower case alphabetic character is entered for this parameter, it
        will be interpreted as a control character.  For example, if '^' is entered for
        Parameter 0 and 'C' is entered for Parameter 1, the revision of the online
        Control-C command will be displayed.
     
          Type:    ASCII character

          Range:   Any printable ASCII character

          Default: None.  If this command is not entered, the revision of all supported
                   ASCII commands in the level specified by Parameter 0 will be displayed.

  Output Data:

    For each command specified, the ASCII command information is displayed as follows.
    
          "Level LL 'CC': Rev XXXX.YYYY, RRRRRR, SSSSSS"
             or
          "All Levels 'CC': Rev XXXX.YYYY, RRRRRR, SSSSSS"
             or
          "Online 'CC': Rev XXXX.YYYY, RRRRRR, SSSSSS"
    
       where
    
          LL     is the Command Level.
    
          CC     is the Command Character.
    
          XXXX   is the Major Revision Number.
    
          YYYY   is the Minor Revision Number.
    
          RRRRRR is either "Overlay" or "Flash".
    
          SSSSSS is the Command help string.
    
  Examples:

    Example #1:
    To display the ASCII command information for all commands supported by the drive.

       F3 C>Q

    Example #2:
    To display the ASCII command informatin for all the commands on Level 2.

       F3 C>Q2

    Example #3:
    To display the ASCII command information for all the online commands.

       F3 C>Q^

    Example #4:
    To display the ASCII command information for the Level 2 'S' (Seek To CHS) command.
    (Both commands will perform the same action.)

       F3 2>S?
       F3 C>Q2,S

    Example #5:
    To display the ASCII command information for the Online ^A (Display Firmware Revision)
    command.

       F3 C>Q^,A

  Revision History:

    0001.0000   Initial revision.