Availability:
     Level 7    , 'u'

  Quick Help:
     Enable/Disable Write Fault, u[Op]
  Description:
    This command enables or disables Write Fault errors.

  Input Parameters:

    0 - Operation.
    
        If Parameter 0 is not set, toggle the current state (not currently supported)
        If Parameter 0 is set to 0, turn write faults off
        If Parameter 0 is set to non-0, turn write faults on
    
          Type:    Unsigned 32-bit value
    
          Range:   0 to 1
    
          Default: none (toggle)
    
  Output Data:

    If no error occurred and write faults were disabled, the following message will be
    displayed.
    
          "Write Faults Disabled"
    
    If no error occurred and write faults were enabled, the following message will be
    displayed.
    
          "Write Faults Enabled"
    
    If the user tried to use the deprecated toggle mode, an error will be set and the
    following message will also be displayed.
    
          "Write Fault Toggle Unsupported"
    
  Revision History:

    0001.0000   Initial revision.
    0011.0000   Combined the PSG Diagnostic Error Codes (PSGDEC) and the Diagnostic External
                Test Service Error Codes (DETSEC) into a single set of Diagnostic Error Codes
                (DiagError).