Availability:
     Level 7    , 'r'
     Level T    , 'R'

  Quick Help:
     Read Non-Volatile Adaptive Parameters, r[Opts]

  Description:
    This command reads the specified adaptive parameters from non-volatile memory.

  Input Parameters:

     0 - Read Adaptive Parameter Options.
    
         This parameter is a bit significant value that specifies which adaptive
         parameters are to be read from non-volatile memory.
    
           Bits 31-3: not used
    
    
           Bit 2: Read SAP.
    
                  If this bit is set the Servo Adaptive Parameters (SAP) will be read
                  from non-volatile memory.
    
    
           Bit 1: Read RAP.
    
                  If this bit is set the Read/Write Adaptive Parameters (RAP) will be
                  read from non-volatile memory.
    
           Bit 0: Read CAP.
    
                  If this bit is set the Controller Adaptive Parameters (CAP) will be
                  read from non-volatile memory.
    
           Type:    Unsigned 32-bit value
    
           Range:   0 to 0xffffffff,
    
           Default: 0x7 (Read the SAP, RAP and CAP)
    
  Output Data:

    If an error occurred, the following information will be displayed.
    
          "DiagError aaaaaaaa"
    
       where
    
          aaaaaaaa is the Diagnostic Error Code
    
  Revision History:

    0001.0000   Initial revision.
    0011.0000   Combined the PSG Diagnostic Error Codes (PSGDEC) and the Diagnostic External
                Test Service Error Codes (DETSEC) into a single set of Diagnostic Error Codes
                (DiagError).