Availability:
     Level 5    , 'W'

  Quick Help:
     Write Servo RAM at Address, W[Addr],[NumBytes],[Data]

  Description:
    The Write Servo RAM at Address command writes the specified Servo RAM locations
    with the specified data.

  Input Parameters:

    0 - Servo RAM Address.
      
        This parameter specifies the address of the first servo RAM byte to be written.
    
          Type:    Unsigned 32-bit value
    
          Range:   0 to 0xFFFFFFFF
    
          Default: None
    
    1 - Number of Bytes.
    
        This parameter specifies the number of servo RAM bytes to be written.
    
          Type:    Unsigned 8-bit value
    
          Range:   1, 2 and 4 are the allowed values
    
          Default: 2
    
    2 - Servo RAM Data.
    
        This parameter specifies that data with which the specified servo RAM location
        is to be written.
    
          Type:    Unsigned 32-bit value
    
          Range:   0 to 0xFFFFFFFF
    
          Default: 0
    
  Output Data:

    If an error occurred, the following information will be displayed.
    
          "DiagError aaaaaaaa"
    
       where
    
          aaaaaaaa is the Diagnostic Error Code
    
  Revision History:

    0001.0000   Initial revision.
    0011.0000   Combined the PSG Diagnostic Error Codes (PSGDEC) and the Diagnostic External
                Test Service Error Codes (DETSEC) into a single set of Diagnostic Error Codes
                (DiagError).