Availability:
     Level 5    , 'R'

  Quick Help:
     Read Servo RAM at Address, R[Addr],[NumBytes]

  Description:
    The Read Servo RAM at Address command reads and displays the data contained in the
    specified Servo RAM locations.

  Input Parameters:

    0 - Servo RAM Address.
      
        This parameter specifies the address of the first servo RAM byte to be read.
    
          Type:    Unsigned 32-bit value
    
          Range:   0 to 0xFFFFFFFF
    
          Default: None
    
    1 - Number of Bytes.
    
        This parameter specifies the number of servo RAM bytes to be read and displayed.
    
          Type:    Unsigned 8-bit value
    
          Range:   1, 2 and 4 are the allowed values
    
          Default: 2
    
  Output Data:


    If an error occurred, the following information will be displayed.
    
          "DiagError aaaaaaaa"
    
       where
    
          aaaaaaaa is the Diagnostic Error Code
    
    If no error occurred, the servo data will be displayed in one of the following three ways.
    
          "Servo Data RAM Addr cccccccc RAM Data dd"            or
          "Servo Data RAM Addr cccccccc RAM Data eeee"          or
          "Servo Data RAM Addr cccccccc RAM Data ffffffff"
    
       where
    
          cccccccc is the address of the first servo memory byte that was read.
    
          dd       is an 8-bit value that was read from servo memory.
    
          eeee     is a 16-bit value that was read from servo memory.
    
          ffffffff is a 32-bit value that was read from servo memory.
    
  Revision History:

    0001.0000   Initial revision.
    0011.0000   Combined the PSG Diagnostic Error Codes (PSGDEC) and the Diagnostic External
                Test Service Error Codes (DETSEC) into a single set of Diagnostic Error Codes
                (DiagError).