Availability:
     Level 4    , 'u'

  Quick Help:
     Set Seek Speed, u[Opts],[SkSpeed]

  Description:
    This command sets the JIT seek speed to be used for future diagnostic seek, read and
    write operations.

  Input Parameters:

    0 - Options.
    
        This parameter specifies options for modifying the Diagnostic Seek Speed.
    
          0 = Display current Diagnostic Seek Speed status
             
                Selecting this option will display the current Diagnostic Seek Speed
                status.
    
          1 = Enable Diagnostic Seek Speed specified by Parameter 1
    
                Selecting this option will enable the Seek Speed specified by Parameter 1
                for future diagnostic seek, read and write operations.
    
          2 = Disable Diagnostic Seek Speed
    
                Selecting this option will disable the Diagnostic Seek Speed.  This
                will allow the Read/Write subsystem to pick the optimum Seek Speed.
    
          Type:    Unsigned 8-bit value
    
          Range:   0 to 2
    
          Default: 0 (Display current Diagnostic Seek Speed status)
    1 - Seek Speed.
    
        If Parameter o is equal to 1, this parameter specifies the JIT speed to be
        used for future diagnostic seek, read and write operations.  The JIT seek
        speed decreases as the parameter value increases, therefore a value of 0
        selects the fastest JIT seek speed.  If a value is entered that is greater
        than the maximum value supported, the slowest supported JIT seek speed will
        be selected.
    
          Type:    Unsigned 8-bit value
    
          Range:   0 to FFh
    
          Default: 0 (Fastest JIT Seek Speed )

  Output Data:


    If an error occurred, the following information will be displayed.
    
          "DiagError aaaaaaaa"
    
       where
    
          aaaaaaaa is the Diagnostic Error Code
    
    If no error occurred, the results of the Set Seek Speed command will be displayed as
    follows.
    
          "Diag Seek Speed c enabled"   or
          "Diag Seek Speed disabled"
    
       where
    
          c is the Diagnostic Seek Speed that is currently selected.
    
  Revision History:

    0001.0000   Initial revision.
    0011.0000   Combined the PSG Diagnostic Error Codes (PSGDEC) and the Diagnostic External
                Test Service Error Codes (DETSEC) into a single set of Diagnostic Error Codes
                (DiagError).