Availability:
     Level 4    , 's'

  Quick Help:
     Display Servo Sector Error Count, s

  Description:
    This command will display the Servo Sector Error Count data.

  Input Parameters:
    None.

  Output Data:


    If an error occurred, the following information will be displayed.
    
          "DiagError aaaaaaaa"
    
       where
    
          aaaaaaaa is the Diagnostic Error Code
    
    If no error occurred, then the output of this command will be displayed as follows:
           
          "                       Error Type  Hd0  Hd1 ...  HdX"
          "          Agc BpFilter Trip Error xxxx xxxx ... xxxx"
          "             Agc Delta Trip Error xxxx xxxx ... xxxx"
          "   Agc Running Average Trip Error xxxx xxxx ... xxxx"
          "         False Predicted Offtrack xxxx xxxx ... xxxx"
          "          Interrupt Overrun Error xxxx xxxx ... xxxx"
          "                Lv Detected Shock xxxx xxxx ... xxxx"
          "            Observer Sector Error xxxx xxxx ... xxxx"
          "   Observer Sector Error Velocity xxxx xxxx ... xxxx"
          "               Pes Detected Shock xxxx xxxx ... xxxx"
          "               Predicted Offtrack xxxx xxxx ... xxxx"
          "                 Rro Parity Error xxxx xxxx ... xxxx"
          "         Timing Mark Not Detected xxxx xxxx ... xxxx"
          "Timing Mark Not Detected Velocity xxxx xxxx ... xxxx"
          "             Unsafe Error Ontrack xxxx xxxx ... xxxx"
    
       where
    
          xxxx indicates the number of the errors of the indicated type for the indicated head.
    
    NOTE: If servo does not support a listed error count type, then the value 'FFFF' will be
    used to indicate an invalid count.
     
  Examples:

    Example #1:
    To display the Servo Sector Error Count data:
 
       F3 4>s

  Revision History:

    0001.0000   Initial revision.