Availability:
     Level 4    , 'e'

  Quick Help:
     Enable / Disable PES Output, e[PesLeftShiftCnt],[DisablePesOut]

  Description:
    This command is used to enable / disable PES Output. When PES Output is enabled, real
    time PES signal will be outputted to AMUX test pin. A Left Shift Number is used to
    control the signal's resolution. First, the 16-bit PES value (Bit 15: sign bit,
    Bits 14 - 12: number of full tracks, Bits 11 - 0: fraction of one track. So 1000h means
    a full track and 800h is half of a track) is left shifted by the number specified in this
    command, and then the high byte of the shifted result is sent out to AMUX.

  Input Parameters:

    0 - PES Output Left Shift Count.
    
       This parameter specifies the number of bits the PES value is to be shifted left
       before it is outputted.
    
       This parameter is only valid if Parameter 1 is not entered. If Parameter 1 is not
       entered and this parameter is not entered, then the current PES output state will
       be displayed.
    
          Type: Unsigned 16-bit value
    
          Range: 0 to 0x000E
    
          Default: None.
    1 - Disable PES Output.
    
       If this parameter is entered, PES output will be disabled. If this parameter is not
       entered and Parameter 0 is entered, PES output will be enabled. If this parameter
       is not entered and Parameter 0 is not entered, the current PES output state will be
       displayed.
    
          Type: Unsigned 16-bit value
    
          Range: 0 to 0xFFFF
    
          Default: None.

  Output Data:


    If an error occurred, the following information will be displayed.
    
          "DiagError aaaaaaaa"
    
       where
    
          aaaaaaaa is the Diagnostic Error Code
    
    When PES Output is enabled, the following will be displayed.
    
          "DiagDac On with Resolution = 2^ xx"
    
       where
    
          xx is the PES Left Shift Number (in Hex format)"
    
    When PES Output is disabled, the following message will be displayed.
    
          "PES output Disabled"
    
  Revision History:

    0001.0000   Initial revision.
    0011.0000   Combined the PSG Diagnostic Error Codes (PSGDEC) and the Diagnostic External
                Test Service Error Codes (DETSEC) into a single set of Diagnostic Error Codes
                (DiagError).