Availability:
     Level 2    , 'N'

  Quick Help:
     Set Direct Write Mode, N[EnableDirWrtModeOpt]

  Description:
    The Set Direct Write Mode commmand enables or disables Direct Write mode.

  Input Parameters:

    0 - Enable Direct Write Mode.
    
        If Parameter 0 is not entered or is equal to 0, the direct write mode will
        disabled and the normal write mode will be restored for the diagnostic write
        operation.
    
        If this parameter is entered and is not equal to 0, the direct write mode
        will be enabled for the diagnostic write operation.
    
          Type:    Unsigned 16-bit value
    
          Range:   0 to 0xFFFFFFFF
    
          Default: 0
    
  Output Data:

    If an error occurred, the following information will be displayed.
    
          "DiagError aaaaaaaa"
    
       where
    
          aaaaaaaa is the Diagnostic Error Code
    
  Examples:
    The following command enables the Direct Write Mode:

       F3 2>N1

    The following commands disable the Direct Write Mode and restore the normal
    write mode:

       F3 2>N
       F3 2>N0

  Revision History:

    0001.0000   Initial revision.