Availability:
     Level 1    , 'e'

  Quick Help:
     Spin Down and Reset Drive, e[MsecDelay],[Opts]

  Description:
    This command spins down the drive, waits the specified number of milliseconds and
    jumps to the Power On Reset function or the Boot Strap Loader.  When jumping to
    the Power On Reset function, a Control Z command will be required to enable the
    Diagnostic Mode commands following the completion of the reset.

  Input Parameters:

    0 - Delay After Spin Down.
    
        This parameter specifies the number of milliseconds to delay after spinning down
        and before resetting the drive.
    
          Type:    Unsigned 16-bit value
    
          Range:   0x1388 to 0xFFFF
    
          Default: 0x1388 (5000 msec or 5 seconds)
    
    1 - Jump to Boot Strap Loader option.
    
        If this parameter is equal to 0x0F, the code will jump to the Boot Strap Loader
        after spinning down the drive.  If this parameter is not equal to 0x0F, the code
        will jump to the Power On Reset function after spinning down the drive.
    
          Type:    Signed 8-bit value
    
          Range:   0 to 0xFF
    
          Default: None
    
  Output Data:
    The following string will be output to indicate that the drive is in the process
    of spinning down.

          "Spinning Down"

    When the spin down is complete, the following information will be displayed.

          "Spin Down Complete"

    
       "Elapsed Time a mins b secs"  or
       "Elapsed Time b.c secs"       or
       "Elapsed Time c.d msecs"
    
    where
    
       a is minutes
       b is seconds
       c is milliseconds
       d is microseconds
    
    When delaying following spin down, the following string will be displayed.

          "Delaying eeee msec"

       where

          eeee is the length of the delay in milliseconds

    After the delay is complete, one of the following strings will be output to indicate
    that the reset is being performed.

          "Jumping to Power On Reset"      or
          "Jumping to Boot Loader"

  Revision History:

    0001.0000   Initial revision.
    0011.0000   Combined the PSG Diagnostic Error Codes (PSGDEC) and the Diagnostic External
                Test Service Error Codes (DETSEC) into a single set of Diagnostic Error Codes
                (DiagError).